so make sure is in up and down postion
next to the petrol tap you will find choke lever
Hi Guys and welcome back to Mini Bikes Store video blog
in today's video I am gonne show you how to start for the first time
the Mini Quadro 49cc mini quad from Nitro Motors
this is brand new product from Nitro motors
it comes with 2 stroke 49cc pull start engine
it also comes in the version with electric start
this is the version without electric start
and I will show you step by step how to start the quad for the first time
with the quad you will receive the mixing bottle
you have to mix petrol the unleaded 95 with 2 stroke oil for motorbikes
in the Ratio 25:1
on the mixing bottle you will find few lines
you have to add fuel up to this line
here
and then the second one
you can see the small one here it says 25:1
then you top up oil up to the second line just here
next close the bottle and shake it well
so now we have the fuel ready you can put that fuel in to the tank
before you put the fuel in to the tank make sure the fuel line is properly connected
now you can add the fuel
this quad has no ignition
so you do not have to be worry about ignition but you need to be sure
that you put the kill switch in postion like this
without the kill switch the quad wont start
and you can check the OFF switch make sure is not stock inside
next here we have the petrol tap
in up and down position is open
so make sure is in up and down position
next to the petrol tap you will find the choke lever
just here
you have to pull the choke lever all the way up and leave it up
next put the left hand on the thumb throttle just here
you may need to press it little bit while pulling
this is an easy pull start so don't pull agresive just pull gently few times till the engine starts
after the quad starts you need to push the choke lever all the way back down
and leave it down when you use the quad and now you can start it again
so after you start the quad for the first time
you need to adjust the engine's idle speed
usually when the quads are new the idle speed of the engine is to high
so you need to lower it
this spring here with the spring on it on the carburetor
that's where you adjust engine's idle speed
so to lower the engines idle speed you need turn this screw in to the left
little bit, start the quad
by turning this screw in to the right you higher the engine's idla speed
so you need to regulate the engine's idle speed to be as low as possible
this is very important for the clutch which is located just here
if the engine's idle speed will be to high
the clutch will be in half open position and will burn out very quick
so that's how the quad should run like
so this are the steps you need to follow
to start the Quadro 49cc from Nitro Motors
after you start for the first time we recommend that you start
the quad and leaving running for few minutes
you have to braking properly engine for arround 3 tanks
so don't go on the full throttle for first 3 tanks
if you like the video don't forget to subsribe to our youtube channel
if you are looking for mini quad for your child
you can check our website the link to our shop is in the description
we have largest selection and best prices of mini quads in Europe
so thanks guys for watching and see you soon
Không có nhận xét nào:
Đăng nhận xét