Auto news on Youtube Apr 8 2018

Hi guys. Welcome back to CzrExperiments. Today we're in the Subaru

and we have a little problem up here with the sunglass holder that we're

gonna fix today. The problem was it stopped staying in there and it would

fall back down so I was driving around for a couple of months like this. So we

took this apart and investigated and found that this little clip here that

holds the the piece there was a little bearing in there that came out of its

track. And with some research on a Subaru forum we found that you can find that

part. Small little part that looks like these

online from under $2 a piece. So we ordered three just to have extras. So

we're gonna take this apart and I'm gonna walk you through how to change

this. And this is a 2014 Subaru Outback. So the first thing you need to do is

remove the screws up here in the sunglass holder. And next you have to

pull this whole piece down. Now this whole piece alone through Subaru would

cost about a hundred bucks or more. So it's definitely worth it to take this

apart. It just requires basically a Phillips screwdriver and maybe a

flathead screwdriver... and the replacement pieces. And you just pull

back here and just put a little pressure it'll pop out and then you pull it

toward the back of the car because it catches in here. So the next step here's

the backside of the piece that's being replaced. So I'm gonna apply pressure

from the front side and for right now I don't have a flathead with me but I have

a pen cap and I'm gonna just stick it right in between here to push this

little clip in.

And I'm gonna kind of rock it...oops...rock it to the side.

And then also slip it in the opposite side. And now I can just push it through

the front side here. And here it is. Looks like this. This little part right here

should be popping in and out and I'll show you one of the replacement pieces.

Here they are side by side. So this piece would normally come in and grasp around

the sunglass holder piece. They both say PR-3 on them. And in

here when you depress it you can see that there's like a little bearing that

rolls around in there in a track. So we'll go ahead and put this in. I'm not

sure if it goes a certain way or not I guess we'll find out. So, I would go ahead

and I think I could put this back first. And I'm just going to make sure it fits in

those pieces. Looks like it's in. And I'll go ahead and put the screws in so I don't

forget. And we'll put the link to the the online store where we bought these

pieces from in the description.

So I'm gonna put it in with the side saying PR three aiming towards the back

of the car we'll try that and hopefully that'll just work. And that snapped in

and let's give it a try and hopefully it'll work here. And that's back to like

brand new again. Thanks for watching. Let us know what you think of this video

in the comments. If you'd like to see more CzrExperiments, be sure to

subscribe so you don't miss the next video. Thanks for watching!