well, as you know
in order to add the break fluid
on this
2005 BMW 530i E60
is kind of hard to locate
but now
we have just added some break fluid
as you see, it´s filled to the top
here it is
until the top
ok
well adjusted
the break fluid is a DOT-4 Syntetyc
in this car
it is only allowed that type of break fluid
so
let´s
put back
everything we have taken away
now put back on their right places
that is
the first piece we will put back AFTER we added the break fluid
which means that it is the LAST to put away in order to add the fluid
so we put it back
that is the piece, we will clean it and then it will locate here
all here
until it touches that edge
then, as wee see, here..
here
we have to put back the screw
this is the screw and we put it there
ok
the screw is on place
and now we put this on place too
very easy
ok
now
this piece
we put it on this position
there
and gently we do this
until we listen to that clic
and that´s it
then..
we put back this piece
goes on this side
a little hard to do it with only one hand
ok
now
here it is well installed
same here
then the microfilter case
there it has to dock itself
all of them
well installed
well installed here too
and then finally
install properly here
and here
finish
it´s good installed
we just finish the installation
so how did we start? Go backwards
here put out the clips and this goes away
then this edge
all this goes away
then this piece
goes away too
this piece also we put it away, like this
and finish, do not forget the screw here
and the break fluid repository is under all of this
down there
that´s it
Không có nhận xét nào:
Đăng nhận xét